Kerbl Technovit-2-Bond PU Hoof Adhesive Starter Set for Cattle, without Dosierpistole

Technovit-2-Bond Hoof Adhesive Starter Set – fast hoof treatment for your herd

When you need to act quickly and reliably in the barn, the hoof adhesive Technovit-2-Bond is the right choice. The starter set gives you a complete system for fixing wood or rubber blocks to healthy hooves, letting you relieve the affected hoof after treatment. This helps you carry out hoof care as efficiently as possible for both you and your animal.

The 2-component PU adhesive impresses with its short curing time of around 30 seconds. Stored above 15 °C, the hoof is fully load-bearing again after roughly three minutes, so your animal can return to the herd quickly. As no separate mixing is required, you save time and avoid unnecessary waste. Whether applied at a 45° or 90° angle, the adhesive bonds strongly and permanently to wood and rubber blocks and withstands daily demands in the barn.

Overview:

• Cures within approx. 30 seconds
• Hoof fully load-bearing again after approx. 3 minutes (stored above 15 °C)
• Application at a 45° or 90° angle possible
• Strong, long-lasting bond to wood and rubber blocks
• No mixing required – simple, low-waste application

Application & Notes:

• Remove the cartridge cap and attach the mixing tip
• First dispense a small amount to allow both components to combine
• Apply a bead of adhesive to the prepared block
• Place the block promptly onto the clean, dry, healthy hoof
• Ensure good ventilation of the work area and avoid skin contact
• Store the cartridge and accessories in a cool, dry place, out of reach of children

Technical Data:

• Type: 2-component PU adhesive for hoof treatment
• Cartridge content: approx. 190 ml, sufficient for approx. 10 applications
• Curing time: approx. 30 seconds
• Load-bearing capacity: after approx. 3 minutes (stored above 15 °C)
• Application angle: 45° or 90°

Scope of Delivery:

1x Technovit-2-Bond cartridge (approx. 190 ml)
10x mixing tips
10x XL wooden blocks
1x Note: available with or without dispensing gun depending on variant

Questions & Answers:

How fast does the hoof adhesive cure?
The adhesive cures within approx. 30 seconds.

When is the hoof load-bearing again after treatment?
Stored above 15 °C, the hoof is fully load-bearing again after approx. 3 minutes.

Does the adhesive need to be mixed before use?
No, no separate mixing is required, so no unnecessary waste is generated.

Hazard information:

Always follow the information on the product label.

Signal word: Danger

Hazard statements (H):

• H315: Causes skin irritation.
• H317: May cause an allergic skin reaction.
• H319: Causes serious eye irritation.
• H332: Harmful if inhaled.
• H334: May cause allergy or asthma symptoms or breathing difficulties if inhaled.
• H335: May cause respiratory irritation.
• H351: Suspected of causing cancer state route of exposure if it is conclusively proven that no other routes of exposure cause the hazard >.
• H412: Harmful to aquatic life with long lasting effects.